Allow adhesive to get tacky and apply cloth, start on one edge of panel or component and work out slowly to ensure no “bubbles” occur.After HP Heatshield Mat has been cut, spray back of cloth and panel or component you are applying HP Heatshield Mat to. Non adhesive product only - Use 3M Super Trim or Super 77 Adhesive.Press the HP Heatshield Mat firmly onto the panel/component, hold while pressing down for 2 minutes.Air bubbles will cause the material to not stick and fall off. Lay the HP Heatshield Mat, start on one edge of panel or component and work out slowly to ensure no “bubbles” occur.Carefully peel the adhesive backing off the HP Heatshield Mat.For part # 720305 & 720505, without adhesive, skip to Step 7. We strongly recommend rubbing the surface with a pre-paint cleaner or isopropyl alcohol (or other non-residue cleaner) after cleaning and degreasing. Degrease and clean surface of any residual chemicals, using carburetor spray or other cleaner/degreaser.Panel or component surface temperature should be at least 65☏, sticking onto anything colder may not allow adhesive to set up properly.Transfer template to HP Heatshield Mat and cut. For surfaces with severe bends, it may be necessary to cut relief lines or wedges to get product to conform. PRO TIP - Use poster board or butcher paper to make a template. Pre-paint cleaner or other non residue cleanerģM Super Trim adhesive or other spray adhesive (Part #720305 & 720505 only) it is not intended to direct contact with heat source. HP Heatshield Mat is intended to be applied on the cold side of panel or component, i.e. Adhesive backed versions will stick to any clean surfaceĬAUTION: THIS PRODUCT IS ELECTRICALLY CONDUCTIVE, BE SURE TO INSULATE ANY TERMINALS, WIRES, OR CIRCUITS THAT MAY COME IN CONTACT WITH THIS PRODUCT HP Heatshield Mat Installation tipsīe sure to use a 1" air-gap between HP Heatshield Mat and heat source for best results.Withstands 1100 Deg F Continuous Radiant (1800 Deg F Intermittent).You can use high-temp glue, silicone, rivets or screws if you choose to go with the non-adhesive version. The HP Heatshield Mat is available with or without a high temperature peel and stick adhesive. It can also be used as a cold air intake heat shield, stick this onto your metal or plastic air box to stop heat from heating up your intake. This is perfect for using underneath your floor pan to shield heat from your DPF, muffler, catalytic converter, and exhaust system, or it can be used on your firewall to shield motor heat. This product withstands 1100 Deg F of radiant heat (requires minimum of 1" of airspace) and up to 450 Deg F of direct heat. Face the aluminized side toward the source of radiant heat to shield heat away. When used in applications where there is 1"+ of airspace and air flow this heat shield cloth is capable of reflecting 90% of radiant heat. Keep your cool in the heat with the HP Heatshield Mat™.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |